1. Setting up the WAN port:
From the menu on the left-hand side of the dashboard select WAN > General Setup from the menu and then go to WAN 2. Please click on the this article for instructions on how to log into the device.
Please make sure to select 'Static or Dynamic IP' in the dropdown box next to WAN2. To configure the details of the internet connection, select the 'Details Page' button that appears on the right of WAN2.
1. Firstly, you need to click on the 'Static or Dynamic IP' tab
Enable: This enables or disables WAN 2. You need to make sure that this is 'Enabled'.
On the right hand side of the page, you need to configure the 'WAN IP Network Settings'.
2. Secondly, select 'Specify an IP Address'.
IP Address: Enter your IP address that has been supplied by Gradwell. You will find this in your handover document and is often referred to as 'Customer Gateway'.
Subnet Mask: Complete this as specified on the handover document
Gateway IP Address: Please copy this over from your handover document. This is often referred to as the 'Gradwell Gateway'.
DNS Server IP Address: You can use the Gradwell DNS servers as below or do feel free to enter any preferred DNS servers that you may wish to use.
Primary IP Address: 184.108.40.206
Secondary IP Address: 220.127.116.11